Phil's Custom Corner Pieces

[gooch]

I have a few structures made by my worker Phil. A few I have had here awhile. One I just pulled out of the kiln today. These are larger pieces with one maybe being considered a mid sized piece.

Now with these branching structures it is almost impossible to not have a few minor defects. They are structurally sound and will ship well. Phil also made a bunch of smaller pieces but Midwest Saltwater snapped them all up.

This piece is as close to perfect as I have seen him make. And it will be a perfect coral island for a smaller tank.
The dimensions are 19.5" long, 14" deep and stands 7" tall. It has 14 holes for Frag Station Disks. Unlike most of our structures thewse have recessed holes so the disks sit flush with the structure. This one is $175 shipped. It is probably the nicest piece he has made.

[gooch]

This one is also nearly flawless. It does have a few minor cracks in it but it is structually sound. It is a beast. 20.75" long, 15" deep and 12" tall. It has 18 holes for Frag Station Disks.
$250 shipped.

[gooch]

This one is also nearly flawless. It does have a few minor cracks in it but it is structually sound. It is a beast. 20.75" long, 15" deep and 12" tall. It has 18 holes for Frag Station Disks.
$250 shipped.

[gooch]

This piece is flawed. It had a few branches break off during the fire. Now if you didn't know that you might not even know. But I know. It also has a deep crack on one of the inner joints. It is not a load bearing joint. I am a 300 pound man and I put a lot of force against it and it did not move. But not all of the holes fit perfectly. It is nothing a dremmel can not fix. I can do it myself but I figure I might as well offer it as is at a reduced cost. If you want me to bore out the holes it will cost $25 more for my time and bits.

It is 19.75" long, 14.5" deep and 11.5" tall. It will be $175 shipped as is or $200 shipped if I bore out the holes. It has 18 holes. Four of these need minor touch up, maybe 30 seconds each. The other hole if you snapped off the stem would work just fine. I just do not have a grinding stone handy and don't know when I will have the time to get to it.