Heidi's Mesh Hex Top

[jimsflies]

http://www.captivereefs.com/jim/mesh/heidi-top.jpg

This is the spot that concerns me...the white you see on the template isn't as much as it looks in these pics. It is very close to the template edge all the way around...but just a bit over in this one spot.

http://www.captivereefs.com/jim/mesh/heidi-top1.jpg

http://www.captivereefs.com/jim/mesh/heidi-top3.jpg


Other sides so you can see...
http://www.captivereefs.com/jim/mesh/heidi-top2.jpg

This pic makes it look crappy....it must be the angle, because it looks a lot better from here. :)
http://www.captivereefs.com/jim/mesh/heidi-top4.jpg

The back will get a plastic back splash...I will make it fit the hex shape, you will need to cut out with scissors for your HOB and cords:
http://www.captivereefs.com/jim/mesh/heidi-top5.jpg

[Heidi]

I bet it is more of a crooked cutting job on my part, and like a said a smidgen too big will be ok, the back sides were a bit smaller then I set the card stock on the tank. :) Thank you again!! can't wait to get it. :thumbsup:

[jimsflies]

I need to get the plastic back splash from preuss tomorrow. I'll take it in with me and see if they have the same tank to try it on. I'd definitely feel a lot more comfortable seeing it on a tank before mailing it. The only thing worse than taking it apart would be mailing it to you and having it not fit right.