Diy razor scraper [Archive]

tazzy695

10-04-2009, 11:17 PM

well i have decided to make a magfloat style razor scraper

what i am doing is i have some extra acrylic laying around so i cut it and made a triangle out of 3 pieces cut a slot in one edge then drilled and tapped for 2 adjustment screws to adjust the blade

I cut the magnets out of a magfloat 125g and glued inside the scraper

I then glued some felt to the bottom and 2 more pices of acrylic to the sides to trap air in so it will float

jojo22

10-05-2009, 05:26 PM

What a useless thread......WITHOUT PICS!!

Would love to see a visual of your project.

tazzy695

10-05-2009, 09:59 PM

I am still working on a final model and I will update with pics of what I have tomarow

tazzy

jojo22

10-05-2009, 10:53 PM

Sounds good to me!

Sir Patrick

10-06-2009, 12:54 AM

Looking forward to the pics!

Timmyb770

10-06-2009, 10:35 AM

Yea me to, would love to see pics!!

tazzy695

10-07-2009, 11:25 PM

ok guys and gals sorry for the delay got realy busy and almost finished with the final version just need to cut the endcaps and install the main magnet but here are a couple of teaser pics of the previous test version

tazzy

http://i281.photobucket.com/albums/kk212/marcp3/10-07-09/IMG_0396.jpg

http://i281.photobucket.com/albums/kk212/marcp3/10-07-09/IMG_0398.jpg

ReeferMike

10-17-2009, 12:34 PM

so the magnet fits inside the triangle above the felt, and the blade screws in the side? i like it!

tazzy695

10-18-2009, 07:05 PM

yes the magnet will be glued inside of the triangel and ends caped on final version

the blade is just slid into a slot cut through the acrylic and the screw is to adjust how much preasure is applied to the blade from top down

I will show better pics with the final version I have also added another magnet to keep the blade from falling out if conection through the glass is lost