[Timezone Detection]
Create Account - Join in Seconds!

User Name: Email Address:
Human Verification

Please enter the six letters or digits that appear in the image opposite.

Soda Ash (baked baking soda) question


Bookmark and Share
Results 1 to 5 of 5
  1. #1
    EMUreef - Reefkeeper
    IT Guru

    Join Date
    May 2010
    Location
    Walled Lake, Michigan
    Posts
    1,030
    Awards March Madness Award - 2013 March Madness Winner Photo of the Month Fishbowl Drawing Winner

    Default Soda Ash (baked baking soda) question

    This question is for anyone that has gone through the process of making their own 2 part.
    My question comes into where you make your own stuff to dose alk.

    i got the process down. bake the baking soda for an hour at 300 degrees take the left over stuff and mix it in with a gallon of RO water than your set to use.
    suppose to mix 2 1/4 cups.

    My question is, if you mix more of the soda ash will the product be higher in dKH? or whatever its called.

    or does there just reason a point that no matter how much you add you dont get any higher values out of it.

    anyone follow that? lol

  2. #2
    CR Member
    Join Date
    Jan 2011
    Location
    Warren
    Posts
    133
    First Name
    Jeff R.Solution
    Awards Photo of the Month - Emerald Eyes Photo of the Month Contest

    Default

    not stealing the thread but, on that same token...

    when turning Baking Soda into Soda Ash you are burning off the Hydrogen. when you mix the Soda Ash into the water and allow it to sit for hours or days before use. what would be the difference from just using the Baking Soda?
    does the Ash allow for a more concentrated solution, as asked above?
    [imglink]http://www.rowelab.com/AquaController/sig.php?n=flynnstone[/imglink]

  3. #3
    BeakerBob - Reefkeeper
    RIP

    Join Date
    Sep 2009
    Location
    Lansing, Michigan
    Posts
    461
    Awards Photo of the Month Photo of the Month

    Default

    The principle purpose of heating the baking soda to convert to soda ash is to drive off the C02 and H2O. The formula is shown here: 2 NaHCO3 -> Na2CO3 + H2O + CO2

    Recipe #1 developed by Randy Holmes-Farley is recommended for use on tanks that have a normal to low pH.

    Why use heated baking soda for tanks with low to normal pH? Because you have driven off the CO2, adding this alkalinity supplement will cause the pH of the tank to increase slightly.

    If you use baking soda out of the box, the addition of the alkalinity supplement will cause a slight decrease in the tank pH due to the presence of CO2. Hence, the reason to use Recipe #2 for tanks with a higher pH.

    The answer to the question is YES, dissolving more heated baking soda (now converted to soda ash) will increase the alkalinity potential of the supplement. However, there is a point where the solution will be saturated and the soda ash will no longer dissolve. This is the same reason that only 1 1/8 cups of baking soda is used in Recipe #2....more will not dissolve.

    For the second post about soda ash in water sitting around and converting back to baking soda (with the CO2 issue): As long as it is kept dissolved in a sealed 1 gallon container, it is good for a long time and will not decrease the tanks pH when added as a supplement.
    BeakerBob - Past MMMC Club President, current Board Member
    imagephp?u1&amptypesigpic&ampdateline1261894023 - Soda Ash (baked baking soda) question

  4. #4
    EMUreef - Reefkeeper
    IT Guru

    Join Date
    May 2010
    Location
    Walled Lake, Michigan
    Posts
    1,030
    Awards March Madness Award - 2013 March Madness Winner Photo of the Month Fishbowl Drawing Winner

    Default

    thanks bob!

  5. #5
    CR Member
    Join Date
    Jan 2011
    Location
    Warren
    Posts
    133
    First Name
    Jeff R.Solution
    Awards Photo of the Month - Emerald Eyes Photo of the Month Contest

    Default

    i was unaware that it would drive off the CO2. that explains alot.
    thanks for your help Bob
    [imglink]http://www.rowelab.com/AquaController/sig.php?n=flynnstone[/imglink]

Similar Topics

  1. Calcium, Alk, Mg & pH Bicarbonate from BRS. Cook it to make it Soda Ash?
    By Tom Toro in forum Chemistry
    Replies: 4
    Last Post: 12-28-2011, 12:07 PM
  2. Calcium, Alk, Mg & pH raising alk with baking soda
    By jolson10450 in forum Chemistry
    Replies: 9
    Last Post: 03-06-2011, 02:00 PM
  3. Question
    By lamajo25 in forum DIY Projects & Plans
    Replies: 0
    Last Post: 07-24-2006, 09:33 PM
  4. Calcium, Alk, Mg & pH Baking Soda recipe needed
    By Whoyah in forum Chemistry
    Replies: 5
    Last Post: 08-18-2005, 10:44 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

About CaptiveReefs

    If you are interested in learning about reefkeeping or have a problem with your reef, our reefkeeping community is here to help. Feel free to ask a question or search our site. We have lots of experienced reefkeepers that are willing to provide free reefkeeping advice!

    Besides being a great resource for all levels of reef aquarium hobbyists, CaptiveReefs is a social experience that will enhance your enjoyment of reefkeeping. CaptiveReefs is committed to connecting reefkeepers with the support and information they need to grow beautiful coral reef aquariums.

Information

Connect with Us