[Timezone Detection]
Create Account - Join in Seconds!

User Name: Email Address:
Human Verification

Please enter the six letters or digits that appear in the image opposite.

DIY Reactor


Bookmark and Share
Results 1 to 6 of 6
  1. #1

    Default DIY Reactor

    This is a quick and easy DIY Reactor that I threw together mostly with spare parts. I only had to go to the hardware store and spend $2. If you do not already have these parts then it might cost you a couple dollars more. I put this together in minutes and since it is over my sump, I didn't bother to glue the PVC. If this is going to sit outside of your sump you will want to use PVC cement to glue everything together and probably a gasket or o-ring for the end caps.

    Reactor1 - DIY Reactor

    Tools:
    Drill with 1/2" & 1/8" bits
    Glue
    Dremel or hole saw

    Materials:
    1 - 2 foot piece of 2 inch PVC or whatever size you want...
    2 - 2 inch PVC couplers
    2 - 2 inch PVC end caps
    2 - plastic maple syrup taps or appropriate hose connectors
    1 - Hose from gravel vac
    1 - Maxi-jet 900 or similar pump
    Acrylic scrap or about 2 inch by 4 inch piece to make discs.


    Directions:
    1. Drill a 1/2 inch hole in the square part of each end cap. This is for the maple syrup taps to enter the reactor. The size of this hole will be different if you something else to connect your hose to the reactor.

    2. Cut down the maple syrup taps as shown in the picture below.
    tap - DIY Reactor

    3. Glue each maple syrup tap into the hole drilled in the end cap.

    4. Unscrew each end cap and measure the diameter of the hole the end cap screws into. This is going to be the same diameter of your acrylic discs.

    5. Use a dremel tool or hole saw to cut discs out of your scrap acrylic to fit into the end cap.

    6. Use the 1/8" drill bit to drill many holes in the two acrylic discs, this will allow water to flow through the reactor while keeping the media inside.

    7. Drop the discs into each end cap and screw back together

    8. Put a 2 inch coupler on each of the end caps.

    9. Put couplers with end caps on the 2 foot section of PVC.

    10. Attach your hose to each maple syrup tap.

    11. Attach the output of your pump to one hose.


    To fill:
    Unscrew one end cap and remove acrylic disc. Fill the reactor with desired media(Phosphate remover, Nitrate remover, carbon, etc.) and replace acrylic disc and end cap.

    To use:
    I place the pump and output hose in the return chamber of my sump. That way the chaeto gets as much of the nutrients as possible before they get to the reactor.

    Here is what it looks like on my sump:
    Reactor - DIY Reactor

    Good luck!

  2. #2

    Default

    Very cool! Nice duplex sump ya got there too. I'm doing something like that in my new tank.
    120G Reef and 40B reef at work, 120G tank dry and dirty in the garage.

  3. #3

    Default

    So far the duplex area is overrun with little mysid shrimp!

    Dave

  4. #4
    Iconz - Reefkeeper CR Member
    Join Date
    Nov 2006
    Location
    Perry, GA
    Posts
    700

    Default

    Is there any reason as to why your macro and your LR is up on the shelf and not directly on the sand?

  5. #5

    Default

    That is to create a benthic zone for water polishers to grow. Should be a perfect environment for sponges, dusters and such to live. Ever notice what is on the underside of most established pieces of LR? Usually a sponge or two, maybe a few little feather dusters and usually some mini brittle stars or other small starfish. The eggcrate layer is an attempt to create a dedicated low light and low flow zone.

    Dave

  6. #6
    hummer - Reefkeeper CR Member
    Join Date
    Nov 2006
    Location
    seneca ,IL
    Posts
    1,044

    Default

    great thread..
    :: hummer :nemo

Similar Topics

  1. Nitrogen Cycle & Phosphate GFO without a reactor?
    By MizTanks in forum Chemistry
    Replies: 12
    Last Post: 02-12-2012, 01:14 PM
  2. Calcium, Alk, Mg & pH Calcium Reactor vs. Kalk Reactor
    By korndiddy20 in forum Chemistry
    Replies: 0
    Last Post: 02-18-2011, 03:16 PM
  3. WTB GFO media reactor, media, Carbon Reactor
    By Black71gp in forum Want to Buy
    Replies: 2
    Last Post: 10-21-2010, 09:06 PM
  4. Calcium, Alk, Mg & pH Got me a new toy....Ca reactor
    By ereefic in forum Chemistry
    Replies: 21
    Last Post: 01-19-2005, 06:25 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

About CaptiveReefs

    If you are interested in learning about reefkeeping or have a problem with your reef, our reefkeeping community is here to help. Feel free to ask a question or search our site. We have lots of experienced reefkeepers that are willing to provide free reefkeeping advice!

    Besides being a great resource for all levels of reef aquarium hobbyists, CaptiveReefs is a social experience that will enhance your enjoyment of reefkeeping. CaptiveReefs is committed to connecting reefkeepers with the support and information they need to grow beautiful coral reef aquariums.

Information

Connect with Us