here is what was done to make this set-up...very easy.
first buy your VHO
kit, then you will need 3 1x8's and 1 1x6.
cut 1 1x8 to 48 1/2" (top)
cut 1 1x6 to 48 1/2" (top)
cut 2 1x8 to 13 3/4" (sides)
mark 45 degree angles on one end of each piece and cut angle.
(angles are so you won't have ends of wood showing).
cut 1 1x8 to 50 1/4" (front)
mark and cut 45 degree angle on both ends.
(be sure you cut the 45's in opposite directions).
now cut 2" strips of wood (shortways) about 8 or so.
measure down from inside top of sides and front 3/4" and mark a straight line.
drill small pilot holes in blocks or the wood will split.
screw blocks to sides and front of canopy.(this will hold it in place on the tank).
now measure down and mark (from other end of wood) at 1 1/2".
drill more pilot holes in blocks and apply them to these marks. (these will hold the top pieces in place).
now the top:
using the pre-cut 1x8 set it inside the canopy (the blocks should catch it so it is level with the sides and front), and screw in place.
using the 1x6 place it inside canopy (block should also catch it), but do not screw.
apply hinges to the 1x8 and leave a gap of 1/4" between boards and attach hinges to 1x6.
attach a handle for easy opening.
i am using aluminum flashing for my reflector.
(just screwed and bent to fit inside of canopy).
install lights and there you have 1 canopy. Attachment 1651 Attachment 1653 Attachment 1654 Attachment 1659 Attachment 1660
more pics to follow when painted and on tank.