I am working on designing my first sump and want feedback. The space I have to work with a closet under the stairs. The space for the sump is about 36" x 36" x 48", accessed through a 20' wide door. Nothing can have a diagonal greater than 36" if it is to be turned once in the closet. I am thinking I will utilize 2 20g Longs and 2 10g tanks. Here is the 3D models I created.
Water from the DT flows into the right side of the middle tier by the skimmer, where it goes through a bubble trap to the pump section. The pump section has a large pump that returns water to the DT and a small pump that sends water up to the top tier for the fuge. The fuge flows to a DSB, and then back into the skimmer section. The two 10g tanks at the bottom act as extra overflow room in case something goes wrong, and a top off holding tank.
Great looking depiction! What did you use make it?
Have you considered using your return pump to route flow back through the fuge? It would probably save some energy, possibly reduce heat (one less pump), and simplify a your setup a little with one less piece of equipment.
Also you should be able to calculate the volume you will need for free board and build that into to your sump without needing the extra bottom tank for overflow.
Great looking depiction! What did you use make it?
Have you considered using your return pump to route flow back through the fuge? It would probably save some energy, possibly reduce heat (one less pump), and simplify a your setup a little with one less piece of equipment.
Also you should be able to calculate the volume you will need for free board and build that into to your sump without needing the extra bottom tank for overflow.
I did the modeling with "Sweet Home 3D", which is free. I didn't create any of the objects... I just found the objects HERE, downloaded it, and imported it in to Sweet Home. Then I could resize it, move it around, etc.
Tapping off of the return pump is a good idea.. hadn't thought about that.
I agree, on the overflow tank, but I have this fear that something might go wrong that causes the entire top-off tank to pump in to the sump. With the extra overflow tank, it can keep that from causing a mess. Plus the 10g tanks are only $12.
Also you should be able to calculate the volume you will need for free board and build that into to your sump without needing the extra bottom tank for overflow.
+1 ^ With the overflow tank setup you currently are planning, you would need to pump the overflowed water back into the sump after a power outage or when you turn off the return for any reason. If you build the sump to allow for it, there is no need for the extra work getting the water back into the system!
When you design your overflow and return if you get a siphon break in it, you should be able to minimize the volume of water that flows back to the sump. (You want to do this anyways so that corals don't sit out of water if they are near the top.)
When you design your overflow and return if you get a siphon break in it, you should be able to minimize the volume of water that flows back to the sump. (You want to do this anyways so that corals don't sit out of water if they are near the top.)
Yep... I'm just always afraid of flooding, especially with the new wood flooring about to go in. I tend to look for the double failsafe solutions. lol