nano led help?

[cg5071]

ok these are some choices I have and I have a couple of questions too. Which of these would be best for a 5g hex nano tank? Low voltage or high, which is better? I also need to know just how I should wire these together so I have 1 plug instead of 3-4. I am also open to other cost friendly simple options like a single driver that would do the same as 3 of these or so. these lights below will only be 30-50 dollars depending and I would like to keep cost in that range.

The canopy on the hex really only leaves an area of 4" x 9" for the lighting and I will be modding the existing canopy. I want as much light as it will take to be able to grow anything. Tank is about 1ft tall.


3w high power led+high power driver(AC60 to 240v)+led and lens included. Which lens if any? available in 30' 45' or 60 Heatsink is also included in each little kit. 18g wiring leads

5w highpower led+low voltage DC12v driver+lens and sink

5w highpower led+low voltage ac85 to 265v driver+lens and sink


Which would be best useable light and easy to wire to 1 or 2 switches. I can request the color light I want. warm or 6700k or 450-470nm blue.

[jolson10450]

what are you asking?

[cg5071]

With the dc 12v could I just wire all 3 or 4 lights to an AC adapter to plug into mains?

[cg5071]

I was editing lol.

[evilc66]

Your first post is still incredibly confusing. If you are looking at some specific products, post links.

[cg5071]

it is a pdf that is too big to post. I will pm it to you though. just a sec. Thanks.

[cg5071]

Sent a pm but I couldnt send the pdf.
Those are each a kit that is listed with the voltage they had next to each one.
A 3w and the other 2 are 5w kits.

[cg5071]

Never mind about these. I think I have it,lol or most of it. I did a calculator type thing online and it said I could use a DE or DI model of a buck puck. It comes out just over $60 for what I want and I believe it will be easier.

I am still confused about one thing though, the power supply. I will have to do some more reading to see what I need in that area. Not sure if I need a special box like I saw or if I can power it with a plug and cord like any 12v adapter.

[evilc66]

You will need a power supply that has an output voltage that is at least 2v higher than the forward voltage of the LED string for the Buckpuck to operate properly. Because the LED limit on the Buckpuck is 6 LEDs in series, a 24v power supply is usually more than enough. At that point, you only have to worry about the amount of current capacity that you need.

[cg5071]

To run both a blue and a white light I should use that splitter thing you have on nano customs? That is the only place I have seen that equipment. OR If it is a similar price I should just get a second puck?

The current capacity would be the rating of the puck? 1000mah? the stars are 350 but can be run at 1000. That is my understanding of this.

Add the FV of all the lights? either 3 or 4 in this case.