Jim,I have a trick that I use that works well for tuening the lights.Leave the apex in auto and change your ramp times in profiles to 1 min.Once you get what you want just change the ramp times to what you had.There will be no change in your lights because it's already fully ramped.I am assueming your changeing this in your profiles of course.Hope that makes sense and helps.Have you considered raiseing your new led to get a wider spread?? Just an idea. Looks good tho
Yeah...most of the time I just use my iphone to control the remote and unfortunately you can't change the profiles via the phone.
I think the key is to shorten the profile time frame...switch the outlet to another steady condition after the profile has completed rather than leave it in that profile. Here is what I ended up doing:
profile 1 ramps from 0 to 20% over 60 minutes
LED virtual outlet was set to from 07:00 to 22:00 to be in Profile 1 (so from 08:00 to 22:00 the leds are at 20%).
Instead use this:
profile 1 ramps from 0 to 20% over 60 minutes
profile 2 ramps from 20% to 20% over 0 minutes
Then LED virtual outlet is set from 07:00 to 08:00 to be in Profile 1
and from 08:00-20:00 to be in Profile 2.
That way if it is changed from manual mode to auto mode during the day, when it is switched back to manual mode, it will run in Profile 2 (20%)...rather than Profile 1 which restarts at 0% and takes an hour to get back to 20%.
Originally Posted by binford4000
Jim,I have a trick that I use that works well for tuening the lights.Leave the apex in auto and change your ramp times in profiles to 1 min.Once you get what you want just change the ramp times to what you had.There will be no change in your lights because it's already fully ramped.I am assueming your changeing this in your profiles of course.Hope that makes sense and helps.Have you considered raiseing your new led to get a wider spread?? Just an idea. Looks good tho
Reply With Quote
